Force Production

11/01/2024

Key lime pie moonshine kinda night

09/18/2024

IM WORKING AT THE LONESTAR BAR TODAY !
Come see me old friends !!

04/07/2024

Our cat hasn’t come home if you seen him he lives on hillcrest lane liberty hill Texas please 🙏 commment me !

09/26/2023

National daughter day !! I love you Rachel Boatman

08/26/2019

Working in shop

08/05/2015

05/25/2015

WORKING IN SHOP

04/19/2015

Yes, Legion cost me over $22,000. We are ok now. Give me a call Sunday at 512-415-671&5

07/14/2014

Waiting on the 1/2-28 tap from Brownells. Then I get to ship to a lucky few, the new compensator s,

07/05/2014

So, I went to work about 6:00 am this morning and this is the FORCE prototype compensator. Have yet to find my 1/2-28 tap, so guess I need to buy another. It is 6061-T6 Aluminum and we are looking for a few people that shoot compensator for evaluation purposes. They will be in the raw state as we fine tune this design. Please email me at [email protected] for inquiries. I will select a few based on shooting disciplines described in your emails.

07/01/2014

Yes, this is my .300 Win-Mag We make the chassis system here at Force Production.

06/29/2014

Please, a MESSAGE to all members that I see too often in barrel placement or replacement. DO NOT OVER TIGHTEN THE V-BLOCK SCREWS! The barrel should be properly seated to the receiver and pay close attention to alignment for extractor. Then V-block placed with with 12-24 screws with equal force. Place BLUE Loc-Tite on screw threads. FINGER TIGHT. If you over tighten this, it creates a fulcrum point, pulling the barrel down from the receiver and you can run out of adjustment on your scope.